No products
The kit uses the SunFounder Nano board as control. A SunFounder Servo Control Board integrates battery, servo, Nano board, and nRF24l01 wireless modules together. This kit is equipped with a SunFounder Mobile Robot Remote Controller so that you can observe and control the robot remotely.
- This is the Crawling Quadruped Robot Kit for Arduino. It includes everything you need to build a cool crawling quadruped robot with wireless remote control.
- Powered by two 18650 rechargeable lithium batteries, it is a four-leg mobile robot and each leg has three joints driven by servos.
- This kit is also equipped with a remote controller so that you can observe and control the robot remotely.
- With the sample sketches provided, you can make the robot move forward, backward, left, and right or dance by remote control.
- You can also make your own sketch to realize different movements.
From 16 years.
Construction time: 4 hours
Level of difficulty: 2 - medium
No soldering necessary.
Delivery contains:
- 1 x pack with acrylic plates
- 1 x calibration chart
- 1 x pack threaded fasteners
- 2 x nRF24l01 module
- 2 x SunFounder Nano board
- 1 x SunFounder Mobile robot remote controller
- 1 x SunFounder Servo Control board
- 2 x Dual 18650 battery holder
- 12 x EMAX ES08AⅡ analog servo
- 1 x USB Data Cable
- 1 x wire harness tube (80 cm)
- 1 x ribbon (50 cm)
- 1 x screwdriver
- 4 x 18650 Rechargeable Li-ion Battery (3.7V, 3400 mAh) without protection circuit board
- 1 x Li-Ion Charger USB with 4 charging slots
Instructions:
see "Download"
Software: